Although the nail-down technique of installing hardwood floor panels is straightforward, it should be done with caution since it must last for many years in whatever form it is installed. During the installation of your hardwood floor panels, you should remove any furniture and barriers from the room that can be removed. Even if it necessitates physical dismantling and reassembly, this is true.
You’ll only have to panel around the fixtures built into the room’s floor. It isn’t the most convenient option, but you must do what you must to get your hardwood floor put. Check out the best vinyl plank flooring in Pittsburgh, PA. Consider the following steps when installing hardwood floor panels:
- Place your first-floor panel in the corner of the room where you want to begin your flooring project. The tongues should face the room, and the grooves should face the wall.
- Begin assembling a row of panels. You’ll need to use that carpenter’s chalk to mark where to cut the last panel because it shouldn’t fit exactly correctly. Cut it with your circular saw. Make sure you don’t chop it too tiny. The fit must be nearly flawless.
- Drill small pilot holes with your drill. Install the nails to secure the floor. Though it will take longer, you’ll be glad you utilized pilot holes when learning how to lay hardwood floors after you’re through.
- Take the other half of the panel you cut off the previous row and use it as the beginning of the following row. It may appear odd at first, but after the floor is finished, the offset of the boards will look fantastic. Furthermore, if all of your boards are identical, the floor will lack interlocking strength.
- Continue in this manner as you work your way through the remaining rows. Make the boards and rows as snug as possible using the rubber mallet. Use the claw hammer to tighten the boards when the rubber mallet doesn’t fit. When you’ve finished your new hardwood floor, the last thing you want is some vast cracks between the boards.
- The last panel is the most challenging to install, but if you rush through this stage, your floor will look terrible. You must meticulously measure, cut, and fit the final panel.
- Make sure the floor you just laid is clean.
However, besides being simple to install and remove, a nailed-down hardwood floor offers several practical advantages over other varieties. The primary benefit to remember is that a glued-down floor is hard; once a floor panel is cured in place, it’s there for good, whether or not it’s tight to the next panel over. The unattached floor might be squeaky, bubbling, and move about because it isn’t linked to anything. So take pleasure in your newly refinished hardwood floor. Check out the best vinyl plank flooring in Pittsburgh, PA.